1. Use a safe spreader and method when lifting the workpiece on the drill bed. Care should be taken to avoid bumping and damaging the device. When you are working to fix the card, you are not allowed to beat hard.
2. It is strictly forbidden to clear sand and correct curved workpieces on the workbench. When hoisting a major workpiece, the rocker arm should leave the workbench to prevent damage to the rocker arm. When the rocker falls, it is necessary to prevent the drill bit from colliding with work.
3. When the drilling machine rotates, the operator is not allowed to leave the post without permission. If the user temporarily leaves the drill pipe, he should raise the drill pipe and turn off the power supply. After parking, he can leave.
4. When the motorized feed is approaching the drill penetration, manual feed is used and the drill must not be stopped before leaving the workpiece.
5. When drilling, if the fuse box is automatically disengaged due to overload, it must be stopped immediately to find the reason.
6. When using cast iron workpieces, do not add cooling water. The bit swarf must always be lifted.
7. It is forbidden to ream holes with a biting bit.
2. It is strictly forbidden to clear sand and correct curved workpieces on the workbench. When hoisting a major workpiece, the rocker arm should leave the workbench to prevent damage to the rocker arm. When the rocker falls, it is necessary to prevent the drill bit from colliding with work.
3. When the drilling machine rotates, the operator is not allowed to leave the post without permission. If the user temporarily leaves the drill pipe, he should raise the drill pipe and turn off the power supply. After parking, he can leave.
4. When the motorized feed is approaching the drill penetration, manual feed is used and the drill must not be stopped before leaving the workpiece.
5. When drilling, if the fuse box is automatically disengaged due to overload, it must be stopped immediately to find the reason.
6. When using cast iron workpieces, do not add cooling water. The bit swarf must always be lifted.
7. It is forbidden to ream holes with a biting bit.
There are many shapes of metal anchors, such as Y-shaped, V-shaped, T-shaped, S-shaped, etc. (see Figure 1). Metal anchors are refractory castables, refractory plastics and refractory spray coatings used to support and fix thinner liners. Which shape of metal anchor to use depends on the structure of the lining. The shape of the Ceramic Anchor is shown in Figure 2. The upper and lower ends must be flat, and the remaining 4 sides are toothed to increase the occlusal area and friction with the lining body, and play a role of suspension and support
Alloy Anchors,Y Anchors,Studs Anchors,Aluminum Alloy Anchors
Puyu kiln technology (jiangsu) CO.,LTD , https://www.anchorpy.com