Contents:
1. There must be safety devices on the hand-pressing planer, and check whether the mechanical parts and protective safety devices are loose or malfunction before operation and check the sharpness of the planing blade and the depth of the knife. After the test runs 1~3m. Only formal work can be carried out. If the blade is blunt, it should be replaced in time.
2, knife depth is generally adjusted to 1 ~ 2mm.
3. Press the wood with your left hand and press it evenly with your right hand. Suspend the slamming card and you must not press your finger on the side of the wood. When plowing, first, plan the large surface as a standard surface, and then plan the small surface.
4. When drawing shorter, thinner wood, push the board to push the wood.
5, the length is less than 400mm, or thin and narrow small material can not be used to planer.
6. When two people operate at the same time, they must push the material over 150mm away from the planing blade.
7. The operator's sleeves should be tightly held and gloves should be worn without any discrimination.
8, should be strictly in accordance with the provisions of the selection of fuses, is strictly prohibited to switch to substitutes.
9, must implement a chassis and a gate protection.
1. There must be safety devices on the hand-pressing planer, and check whether the mechanical parts and protective safety devices are loose or malfunction before operation and check the sharpness of the planing blade and the depth of the knife. After the test runs 1~3m. Only formal work can be carried out. If the blade is blunt, it should be replaced in time.
2, knife depth is generally adjusted to 1 ~ 2mm.
3. Press the wood with your left hand and press it evenly with your right hand. Suspend the slamming card and you must not press your finger on the side of the wood. When plowing, first, plan the large surface as a standard surface, and then plan the small surface.
4. When drawing shorter, thinner wood, push the board to push the wood.
5, the length is less than 400mm, or thin and narrow small material can not be used to planer.
6. When two people operate at the same time, they must push the material over 150mm away from the planing blade.
7. The operator's sleeves should be tightly held and gloves should be worn without any discrimination.
8, should be strictly in accordance with the provisions of the selection of fuses, is strictly prohibited to switch to substitutes.
9, must implement a chassis and a gate protection.
Copper Row,Copper Busbar,Busbar Copper Row,Copper Flat Bar,Copper Flat Busbar
LIAOCHENG CHANGYI METAL MATERIAL CO., LTD. , https://www.cnsteelsheet.com