Agricultural vehicles save fuel and energy-saving 12 strokes

1. Ensure that the tire pressure is correct The tire pressure is insufficient or too high, which will increase the fuel consumption. Therefore, the tire pressure should be checked regularly.

2. Do not change the size of tires as you like. Selecting a wider tire may make your vehicle look more stylish, but the wider the tire, the greater the resistance of the wheel, so unless you need extra driving ability, you are wasted Oil.

3. Regularly check whether your steering wheel and tire are adjusted properly. The vehicle is used for a long time. Tires and steering wheels tend to increase freedom due to wear, which also consumes more fuel.

4. Use the lubricant with the lowest viscosity as much as possible. The vehicle's manual contains the lowest viscosity lubricant that the vehicle can use. The lower the viscosity of the lubricant, the more energy-efficient the engine is, and the more fuel-efficient it is.

5, serious maintenance of the engine found that the fault should be immediately ruled out, because any engine failure will reduce its power and economy, wasting fuel.

6, to avoid the car trailer to pull some of the owners to achieve the purpose of multiple loads, their own trailers, so that the trailer is big and heavy, which not only does not meet the safety requirements, but also increase the vehicle resistance. In addition, fuel consumption will be greatly increased when the vehicle is empty.

7. Don't warm up for a long time. Some drivers like to start the engine before it starts driving in the morning. It is a good habit to warm up for a while. However, it is undoubtedly a waste of preheating time. Allowing the locomotive to travel slowly for 1 km to 2 km can also achieve the purpose of preheating.

8. If you need to stop for a long time, please turn off the engine. Because idling for a long time not only damages the engine, but also consumes fuel.

9, do not slam the throttle when accelerating Do not develop the habit of accelerating with the fierce step on the throttle, slam the accelerator not only to make the machine subject to the impact of a huge inertia force, and the excessive supply of fuel can not be completely burned, become black smoke, Causes waste of oil.

10, according to the speed required to shift gear should be selected in accordance with the speed requirements of the appropriate gear, as far as possible without low throttle method to increase speed, because doing so will also cause fuel waste.

11, not speeding For the average agricultural vehicle, the speed of 50 km to 70 km per hour is the most fuel-efficient speed, this time the speed increase of 1 km per hour will increase fuel consumption by 0.5%.

12. Do not overload the shipment as required.

Materials Hoist

Materials Hoist:

Material Hoist is a kind of mechanical conveying equipment with fixed device.Safety device for rope breaking, safety device for stopping, buffer device, height and limit device, rope preventing device and other safety devices are set up.

Materials Elevator is reliable and easy to operate and maintenance. The highest working lifting height can up to 80m.


SS Series building hoist is driven by steel rope. It's a vertical conveyance which is used to carry material.

SS Simple Materials Lift is novel structure, high performance&lower cost, easy install and dismantle.



Materials Hoist Specification Table:

Aluminum Plate Punching Wire Mesh For Construction Hoist

ITEM

UNIT

SS100/100

SS100

Rated Load

kg

1000/1000

1000

Lifting speed

m/min

23.5

23.5

Standard height

m

24

24

Max lifting height

m

80-130

80-130

Cage size

m

2.8*1.5*1.9

2.8*1.5*1.9

Mast section size

m

0.65*0.65*1.5 or 0.8*0.8*1.5

0.65*0.65*1.5 or 0.8*0.8*1.5

Motors power

kw

7.5*2

7.5

Wirerope

/

6*37+1-12-1670-R

6*37+1-12-1670-R

Weight for 24m height

kg

4350

3340

Mast section main limb

mm

Φ76*4

Φ76*4


Application Area:

Materials Hoist is mainly used for continuous vertical lifting of powder, granule and small pieces of material on site. It is usually used in conjunction with Tower Crane on site. It is widely used in the lifting of bulk materials in feed mills, flour mills, rice mills, oil plants, amylum plants, grain depots, port terminals and so on.

If you have any questions, please contact with us directly. Materials Hoist are produced with High Quality and Good Appearance. Welcome you can visit our Factory. For inqury, Please send mail directly to us.


Materials Hoist,Twin Cabinets Materials Hoist,Single Cabinets Materials Hoist,Hoist Material Elevator

Jinan East Machinery Co.,Ltd. , https://www.jneastmach.com