1, to prevent the device from hitting the water bearing heater is an electronic component, so the electronic components are not allowed to touch the water in the case of power, if it is powered, it is not careful to let water touch the components above the circuit board Immediately turn off the power, then remove the circuit board, clean it with paper first, then dry it with a hair dryer, and then dry it in a place that is ventilated under the sun.
2. Periodically clean the dust-bearing induction heater of the bearing heater. After a period of time, there will be some dust on the fan and the circuit board. At this time, you need to use a brush or dust. The first step is dust removal from fans and circuit boards. The dust on the bearing heaters can be disposed of every two or more months, including the dust on top of the fan and above the control board.
Especially the dust on the fan, due to a long time the fan above the dust, but not finishing, then the dust will affect the normal operation of the fan, turn slow or maybe not turn on the heat dissipation of the circuit board there is a big influences. If the heat is not good, the circuit board will stop the heating operation due to overheating maintenance. Therefore, it is very important for the dust removal of the fan.
3. The interval between the multiple bearing induction heaters is on the same platform. The working principle of the bearing heater is that the electric current will generate electromagnetic waves in the future through the high temperature line. The electromagnetic wave will affect the iron molecules in the material cylinder and cause the iron molecules to violently move. , and then fever. However, the electromagnetic waves generated by each bearing heater are different, and the interval is probably more than 7 cm. (If you look for a job, go to the list.) If the interval between the high-temperature lines of the two bearing heaters is too close to the interval within 5 cm, the electromagnetic waves that occur will disturb each other, which will also affect the bearing heaters. The use of life.
4, of course, need to understand the daily maintenance of bearing induction heaters, which lay a solid foundation for our safety production, and get better returns. Bearing heater body is not magnetic, does not heat itself, high temperature bearing heater is the quality of the bearing heater.
Dear Customer:
Thank you for using our DGT series drum sand drencher, please give us your feedback or suggestions in time after use, we will be very grateful for your support. Before using this robot, please read the following carefully, which will be of great help to device problems in the future.
1. The voltage used by this equipment must meet the national grid power supply standard.
2. The compressed air pressure range used by this equipment: ≧0.5-0.7MPa.
3. The operator must read this manual carefully before use, and operate in strict accordance with the operating procedures.
Sanding Equipment,Sanding Coat Machine,Drum Sanding Machine,Drum Sanding Equipment
Dongying Dosun Mechanical Automation Co.,LTD , https://www.dosunmachinery.com