1 When grinding the workpiece by hand, the hand should be more than 50mrn away from the grinding wheel. Do not hold it too tightly.
2 When feeding material with push rods, push the material stick firmly, and do not use metal rods.
3 When adjusting the grinding amount, the test grinding work must not be less than three.
4 When dressing the grinding wheel, slowly inject and give sufficient coolant to prevent damage to the diamond.
5 When the workpiece is inclined in the middle of the wheel, it must be stopped in an emergency.
6 When grinding the bar stock, it is required to align the rack with the center between the grinding wheel and the guide wheel. Do not wear material.
7 When the workpiece is not worn out from the grinding wheel, the workpiece must not be removed. When the workpiece is connected to the workpiece, the workpiece must be quickly grasped and stopped.
8 The workpiece on the rack should be put away to prevent it from rolling off and hurting people.
9 When installing the spiral wheel, wear gloves and hold the inner hole of the end face of the spiral wheel. Do not take the outside of the spiral wheel.
10 The blade of the unmotivated sharpening board must be blunt to prevent cutting the hand.
11 Do not add more than one size of material. When you find an overstock, remove it immediately to prevent accidents.
2 When feeding material with push rods, push the material stick firmly, and do not use metal rods.
3 When adjusting the grinding amount, the test grinding work must not be less than three.
4 When dressing the grinding wheel, slowly inject and give sufficient coolant to prevent damage to the diamond.
5 When the workpiece is inclined in the middle of the wheel, it must be stopped in an emergency.
6 When grinding the bar stock, it is required to align the rack with the center between the grinding wheel and the guide wheel. Do not wear material.
7 When the workpiece is not worn out from the grinding wheel, the workpiece must not be removed. When the workpiece is connected to the workpiece, the workpiece must be quickly grasped and stopped.
8 The workpiece on the rack should be put away to prevent it from rolling off and hurting people.
9 When installing the spiral wheel, wear gloves and hold the inner hole of the end face of the spiral wheel. Do not take the outside of the spiral wheel.
10 The blade of the unmotivated sharpening board must be blunt to prevent cutting the hand.
11 Do not add more than one size of material. When you find an overstock, remove it immediately to prevent accidents.
4 Ton Wheel Loader,Machine Loader,Industrial Loaders,Small Loader Machine
Sichuan Everest Lovol Construction Machinery Co,.LTD , https://www.everestlovol.com