Chassis Model ZZ3167M3811
Engine Model WD615.62 Euro II
Driving Type 4x2(xx)
Over all Dimension 8400X2500X3370(mm)
(kg) Payload 9000
Kerb Mass 9970
G. V. W. 19000
(mm)Wheel Base 4600
(km)Max. Speed 90
(L) Tank Volume 8000
(m) Suction deepth >5
(min) Loading time<12
(r/min)Pump rotating speed 500
MPa Max. Vacuum degree <0.03
° Max. Tank tipping angle 70
(s) Tipping time <45
°
Rear cover Max. Open angle 70
(s)Rear cover open time <10 Item Specification
Chassis Model ZZ3167M3811
Engine Model WD615.62 Euro II
Driving Type 4x2(xx)
Over all Dimension 8400X2500X3370(mm)
(kg) Payload 9000
Kerb Mass 9970
G. V. W. 19000
(mm)Wheel Base 4600
(km)Max. Speed 90
(L) Tank Volume 8000
(m) Suction deepth >5
(min) Loading time<12
(r/min)Pump rotating speed 500
MPa Max. Vacuum degree <0.03
° Max. Tank tipping angle 70
(s) Tipping time <45
°
Rear cover Max. Open angle 70
(s)Rear cover open time <10
General Provisions
1.boat type floating mooring device for single point mooring equipment (hereinafter referred to as single point mooring), also can use multi point positioning system; semi submersible device use multi-point Mooring System for offshore mooring positioning.
2.single point mooring device forms including but not limited to: internal turret single point mooring device, outer turret single point mooring device, single point Mooring Buoy catenary device, single anchor leg mooring buoy device of tower, soft yoke single point mooring system.
3.floating positioning device of the mooring system design, construction and maintenance of certification and inspection agencies should comply with the norms and standards and / or use norms and standards.
Photo of our Mooring System:
position mooring system
mooring system can be divided into: (1) multi point mooring system; (2) single point mooring system in various forms, the mooring system can be divided into: a) no thruster assisted mooring system; and b) thruster assisted mooring system. (3) dynamic positioning system
mooring cable
By the combination of strength of mooring cable, fiber cable, anchor or mooring cable and above. The mooring cable can also be provided with an elastic float and / or weight. When the elastic mooring buoy and / or weight, you should consider the effect of the acceleration and the possible resonance effect.
Pre tension
When the floating device is determined by the mean shift, the size of the pre tension is allowed to adjust the tension distribution of the Mooring Rope. 4.2.4 thruster assisted mooring system
Thruster assisted mooring system
floating device is provided with a thruster, all or part of the net thrust effect can be considered in all design conditions. The effect depends on the thruster control system and design conditions. The thruster can be manual control or automatic control.
Mooring design criteria
The 4.4.1 design of the mooring system should comply with the norms and standards of certification and inspection agencies and / or the specification and standard requirements:
(1) average deviation and the maximum offset; (2) mooring cable tension; (3) grip anchor system; (4) mooring cable fatigue life.
Mooring System
Anchor Windlass,Mooring Rope,Mooring Winch,Mooring System
Unisite Group Ltd. , https://www.shipsparts.nl