How much do you know about the problem of carving machine knives?

I. Q: The carved software tool is locked. What can I do if I cannot delete it?

A: The first step is of course to close the software and reopen it. Note that instead of opening the carved document, click on the “Tool path” menu in the processing module interface. Continue to pull down and select “Tools library” from the list. After that, all the tools at this time are not locked and you can delete them yourself.

Second, Q: What happened when the engraving machine appeared on occasional knives?

A: This phenomenon is mainly caused by loss of control of the Z axis. Other reasons are as follows:

1, the problem of the control card. Excessive working hours can cause the control card to overheat, making the control card unstable. When not using the machine, turn off the computer and the machine.

2. The aging of electrical devices and accessories. This may be caused by machine assembly problems, loose screws, loose couplings, non-perpendicular Z axis, broken sliders, and nuts.

3, voltage instability. Problems occur with regulators.

4, the cause of static interference. For this reason as long as the ground wire can be, if you do not know can directly consult the manufacturers, Guangdong carved machine manufacturers - Shenzhen Haoda NC Equipment Co., Ltd. pre-sale in the sale to provide one-stop quality service.

5, processing problems. For example, if the speed of the knife is set too fast or the knife is too deep, it will generally cause the carving machine to knives.

6, the problem of the program. No detailed explanation is provided here, and you can consult the engraving machine manufacturer directly if you do not understand it.

Third, Q: When the CNC engraving machine tool change, the spindle is not loose knife is what causes it?

Answer: The spindle is not loose for the following three reasons:

1. The pressure of the air source may be relatively small or the flow rate is not enough.

2. There may be a problem with the cylinder of the CNC main shaft loose knife.

3. There may be problems with the broaching system of the spindle of the machine tool, such as damage to the disc spring.